Makita TW004G Instruction Manual page 8
Hide thumbs
Also See for TW004G:
- Instruction manual (68 pages) ,
- Instruction manual (16 pages) ,
- Instruction manual (17 pages)
Table of Contents
Advertisement
Available languages
Available languages
Changing the application mode
Changing the impact force
You can change the impact force in four steps: 4 (max), 3 (hard), 2 (medium), and 1 (soft).
This allows a tightening suitable to the work.
The level of the impact force changes every time you press the button .
You can change the impact force within approximately one minute after releasing the switch trigger.
NOTE: You can extend the time to change the impact force approximately one minute if you press the but-
ton
or
.
► Fig.7
Application mode
(Impact force grade displayed on panel)
4 (Max)
3 (Hard)
2 (Medium)
1 (Soft)
: The lamp is on.
Example of application
Application mode
(Impact force grade displayed on panel)
4 (Max)
3 (Hard)
2 (Medium)
1 (Soft)
Maximum blows
-1
4,000 min
(/min)
-1
3,400 min
(/min)
-1
2,600 min
(/min)
-1
1,800 min
(/min)
Assembling steel frames and tightening long screws or bolts.
Assembling steel frames.
Assembling or disassembling scaffolds and frameworks.
Assembling furniture.
8 ENGLISH
Purpose
Tightening with the maximum force and
speed.
Tightening when the force and the speed
are desired.
Tightening with less force and speed than
Max mode (easier to control than Max
mode).
Tightening when the force and the speed
are desired.
Tightening when a good finishing is
needed.
Tightening when you need good control
power.
Tightening with less force to avoid screw
thread breakage.
Tightening when you need fine adjustment
with small diameter bolts.
Example of application
Advertisement
Table of Contents
