Remove And Replace Ssd - Cisco NCS 1001 Hardware Installation Manual
Hide thumbs
Also See for NCS 1001:
- Manual (8 pages) ,
- Configuration manual (36 pages) ,
- Start manual (40 pages)
Table of Contents
Advertisement
Remove and Replace SSD
Step 5
Use the control card handle to remove the control card completely.
Remove and Replace SSD
Note
Procedure
Step 1
Loosen the two captive screws in the Removable Disk slot on the back side.
Step 2
Slide out the SSD from the Removable Disk slot.
Figure 45: Remove SSD
To replace a SSD:
Step 3
Slide the SSD into the Removable Disk slot.
Step 4
Tighten the two captive screws to secure the SSD into place.
Hardware Installation Guide for Cisco NCS 1001
48
If the SSD is removed, it needs to be physically replaced within 10 minutes. If NCS 1001 runs without the
SSD, the SSD metallic cover must be placed to close the SSD slot.
To remove a SSD:
Replace Cisco NCS 1001 Components
Advertisement
Table of Contents
