Table of Contents
Advertisement
Installing a Network Module in the Switch
Network Module
C9300X-NM-8M
C9300X-NM-8Y
page 68
C9300X-NM-BLANK
Note
Installing a Network Module in the Switch
Safety Warnings
This section includes the installation cautions and warnings. Translations of the safety warnings are available
in the Regulatory Compliance and Safety Information for Cisco Catalyst 9300 Series Switches.
Read this section before you install a network module.
Caution
Warning
Warning
Installing a Network Module
Note
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
68
Description
3
This module has eight Multigigabit Ethernet (mGig) module slots.
2, on
This module has eight 25 GE/10 GE/1 GE slots with an SFP28 port in each slot.
This is a blank module.
1. Supported only on Cisco Catalyst 9300 Series Switches.
2. Supported only on Cisco Catalyst 9300X Series Switches.
3. Supported only on C9300X-24Y.
Proper ESD protection is required whenever you handle equipment. Installation and maintenance personnel
should be properly grounded by grounding straps to eliminate the risk of ESD damage to the equipment.
Equipment is subject to ESD damage whenever you remove it.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Do not reach into a vacant slot or chassis while you install or remove a module. Exposed circuitry could
constitute an energy hazard. Statement 206
The switch can operate without a network module, but a blank module (with no ports or SFP slots) is available
and should be installed when uplink ports are not required.
Installing a Network Module
- Quick Links:
- Front Panel Components
- 10/100/1000 Ports
Hide quick links:
Advertisement
Table of Contents
