Table of Contents
Advertisement
Figure 76. Removing the right control panel
Next steps
Replace the right control
Installing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the front
bezel.
4.
Remove the air
shroud.
Steps
1. Route the control panel cable through the side wall of the system and slide the cable into the clip.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the right control panel in the slot on the system.
3. Connect the right control panel cable to the connector on the system board.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
panel.
Safety
Before working inside your
instructions.
system.
Installing and removing system components
81
Advertisement
Table of Contents
