Integrated Dell Remote Access Controller 6; (Idrac6) Express Card (Optional); Installing An Idrac6 Express Card - Dell PowerEdge T410 Hardware Owner's Manual
Dell server hardware owner's manual
Hide thumbs
Also See for PowerEdge T410:
- Getting started with (63 pages) ,
- Technical manual (57 pages) ,
- Technical manualbook (56 pages)
Table of Contents
Advertisement
Integrated Dell Remote Access Controller 6
(iDRAC6) Express Card (Optional)
Installing an iDRAC6 Express Card
WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 90.
4 To install the iDRAC6 Express card:
Insert the notch on the iDRAC6 Express card into the clip on the
a
system board.
Align the front edge of the card with the connector on the system
b
board. See Figure 6-1 for the location of the connector.
Press the card down until it is fully seated. See Figure 3-20.
c
When the front of the card is fully seated, the plastic standoff tab
snaps over the edge of the holder.
5 Close the system. See "Closing the System" on page 91.
6 Place the system upright and on its feet on a flat, stable surface.
7 Rotate the system feet outward.
8 Reattach any peripherals and connect the system to an electrical outlet.
9 Turn on the system and attached peripherals.
Only trained service technicians are authorized to remove the system
Installing System Components
127
Advertisement
Table of Contents
Troubleshooting
