Installing A Hot-Swap Hard Drive - Dell PowerEdge T410 Hardware Owner's Manual
Dell server hardware owner's manual
Hide thumbs
Also See for PowerEdge T410:
- Getting started with (63 pages) ,
- Technical manual (57 pages) ,
- Technical manualbook (56 pages)
Table of Contents
Advertisement
Installing a Hot-Swap Hard Drive
CAUTION:
the SAS/SATA backplane.
CAUTION:
installation. See the documentation supplied with your operating system for more
information.
CAUTION:
configuration is not supported.
1 Remove the front bezel. See "Removing the Front Bezel" on page 85.
2 Press the button on the front of the drive carrier, rotate the carrier handle
outward, and remove the carrier from the drive bay.
3 Install the hard drive carrier on the hard drive.
Insert the hard drive into the hard-drive carrier with the connector
a
end of the drive at the rear. See Figure 3-8.
Align the screw holes on the hard drive with the holes on the hard-
b
drive carrier.
When aligned correctly, the rear of the hard drive will be flush with
the rear of the hard-drive carrier.
Attach the four screws to secure the hard drive to the hard-drive
c
carrier. See Figure 3-8.
96
Installing System Components
Use only hard drives that have been tested and approved for use with
Not all operating systems support hot-swappable hard drive
Combining SATA and SAS hard drives in the same system
Advertisement
Table of Contents
Troubleshooting
