Table of Contents
Advertisement
2.1.3 Contact sensor
To disassemble the MP730, perform steps (1) through (4).
(1) Remove the 4 screws (a); then while freeing the claw, detach the rear cover.
(2) Remove the screw (b), and detach the grounding cable.
(3) Disconnect the connector JADF3 of sensor board sub PCB.
(4) Detach the cable guide from the main unit, and lift the ADF ass'y to detach. (The cable
is shown freed from the cable guide in the figure; however, do not free it in the field.)
Rear cover
Claw
MultiPASS MP730/MP700 Chapter 3: Assembly and Disassembly
ADF ass'y
Cable
guide
a
a
Figure 3-11 Contact Sensor 1
3-13
b
Advertisement
Table of Contents
