Table of Contents
Advertisement
Available languages
Available languages
RESHARPENING THE CUTTING TOOL
CAUTION: The cutting tools mentioned below must only be resharpened by an
authorized facility. Manual resharpening will result in imbalances
of the cutting tool causing vibrations and damage to the equipment.
– cutter blade (star blade (4 teeth), eddy blade (8 teeth), brush blade(3 teeth))
An expert resharpening and balancing service is provided by Authorized
Service Agents.
NOTE: To increase the service life of the cutter blade (star blade, eddy blade)
it may be turned over once, until both cutting edges have become blunt.
NYLON CUTTING HEAD
The nylon cutting head is a dual string trimmer head capable of both automatic and bump & feed mechanisms.
The nylon cutting head will automatically feed out the proper length of nylon cord by the changes in centrifugal force caused by increasing or
decreasing RPMS. However, to cut soft grass more efficiently, bump the nylon cutting head against the ground to feed out extra cord as
indicated under operation section.
Operation
– Increase the nylon cutting head speed to approx. 6,000 min
Low speed (under 4,800 min
properly at low speed.
– The most effective cutting area is shown by the shaded area.
If the nylon cord does not feed out automatically, proceed as follows:
1. Release the control lever to run the engine idle and then squeeze the control
lever fully. Repeat this procedure until the nylon cord feeds out to the
proper length.
2. If the nylon cord is too short to feed out automatically with the above
procedure, bump the knob of the nylon cutting head against the ground to
feed out the nylon cord.
3. If the nylon cord does not feed out with procedure 2, rewind/replace the
nylon cord by following the procedures described under "Replacing the nylon
cord".
-1
) is not suitable, the nylon cord will not feed out
-1
.
16
Most effective cutting area
Idle speed
Full speed
Knob
Advertisement
Chapters
Table of Contents
