Hardware Compatibility And Sdm Mismatch Mode In Switch Stacks - Cisco Catalyst 3750-E Software Configuration Manual
Hide thumbs
Also See for Catalyst 3750-E:
- Getting started manual (27 pages) ,
- Product support bulletin (6 pages) ,
- Configuration handbook (359 pages)
Table of Contents
Advertisement
Understanding Switch Stacks
If you add a provisioned switch that is a different type than specified in the provisioned configuration to
a powered-down switch stack and then apply power, the switch stack rejects the (now incorrect) switch
stack-member-number provision type global configuration command in the startup configuration file.
However, during stack initialization, the nondefault interface configuration information in the startup
configuration file for the provisioned interfaces (potentially of the wrong type) is executed. Depending
on the differences between the actual switch type and the previously provisioned switch type, some
commands are rejected, and some commands are accepted.
For example, suppose the switch stack is provisioned for a 48-port switch with Power over Ethernet
(PoE), the configuration is saved, and the stack is powered down. Then a 24-port switch without PoE
support is connected to the switch stack, and the stack is powered up. In this situation, the configuration
for ports 25 through 48 is rejected, and error messages appear during initialization. In addition, any
configured PoE-related commands that are valid only on PoE-capable interfaces are rejected, even for
ports 1 through 24.
If the switch stack does not contain a provisioned configuration for a new switch, the switch joins the
Note
stack with the default interface configuration. The switch stack then adds to its running configuration a
switch stack-member-number provision type global configuration command that matches the new
switch.
For configuration information, see the
page
Effects of Replacing a Provisioned Switch in a Switch Stack
When a provisioned switch in a switch stack fails, is removed from the stack, and is replaced with
another switch, the stack applies either the provisioned configuration or the default configuration to it.
The events that occur when the switch stack compares the provisioned configuration with the
provisioned switch are the same as those described in the
Switch Stack" section on page
Effects of Removing a Provisioned Switch from a Switch Stack
If you remove a provisioned switch from the switch stack, the configuration associated with the removed
stack member remains in the running configuration as provisioned information. To completely remove
the configuration, use the no switch stack-member-number provision global configuration command.
Hardware Compatibility and SDM Mismatch Mode in Switch Stacks
The Catalyst 3750-E switch supports only the desktop Switch Database Management (SDM) templates.
All stack members use the SDM template configured on the stack master.
Version-mismatch (VM) mode has priority over SDM-mismatch mode. If a VM-mode condition and an
SDM-mismatch mode exist, the switch stack first attempts to resolve the VM-mode condition.
You can use the show switch privileged EXEC command to see if any stack members are in
SDM-mismatch mode.
For more information about SDM templates and SDM-mismatch mode, see
SDM Templates."
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
5-10
5-23.
5-8.
"Provisioning a New Member for a Switch Stack" section on
"Effects of Adding a Provisioned Switch to a
Chapter 5
Managing Switch Stacks
Chapter 8, "Configuring
OL-9775-08
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
