Default Settings After Initial Switch Configuration
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Default Settings After Initial Switch Configuration
The switch is designed for plug-and-play operation, requiring only that you assign basic IP information
to the switch and connect it to the other devices in your network. If you have specific network needs,
you can change the interface-specific and system- and stack-wide settings.
Note
For information about assigning an IP address by using the browser-based Express Setup program, see
the getting started guide. For information about assigning an IP address by using the CLI-based setup
program, see the hardware installation guide.
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
1-16
SPAN and RSPAN support of Intrusion Detection Systems (IDS) to monitor, repel, and report
network security violations
Four groups (history, statistics, alarms, and events) of embedded RMON agents for network
monitoring and traffic analysis
Syslog facility for logging system messages about authentication or authorization errors, resource
issues, and time-out events
Layer 2 traceroute to identify the physical path that a packet takes from a source device to a
destination device
Time Domain Reflector (TDR) to diagnose and resolve cabling problems on 10/100 and
10/100/1000 copper Ethernet ports
SFP module diagnostic management interface to monitor physical or operational status of an SFP
module
Digital Optical Monitoring (DOM) of connected SFP modules
Online diagnostics to test the hardware functionality of the supervisor engine, modules, and switch
while the switch is connected to a live network
On-board failure logging (OBFL) to collect information about the switch and the power supplies
connected to it
Enhanced object tracking (EOT) for HSRP to determine the proportion of hosts in a LAN by tracking
the routing table state or to trigger the standby router failover
IP Service Level Agreements (IP SLAs) support to measure network performance by using active
traffic monitoring
IP SLAs EOT to use the output from IP SLAs tracking operations triggered by an action such as
latency, jitter, or packet loss for a standby router failover takeover
EOT and IP SLAs EOT static route support to identify when a preconfigured static route or a DHCP
route goes down
Flow-based Switch Port Analyzer (FSPAN) to define filters for capturing traffic for analysis
Embedded event manager (EEM) for device and system management to monitor key system events
and then act on them though a policy
Support for EEM 3.2, which introduces event detectors for Neighbor Discovery, Identity, and
MAC-Address-Table
Chapter 1
Overview
OL-9775-08