hit counter script

Ntp Broadcast - Cisco nexus 3000 series Command Reference Manual

Nx-os system management
Hide thumbs Also See for nexus 3000 series:
Table of Contents

Advertisement

Chapter
System Management Commands
S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m

ntp broadcast

To enable a Network Time Protocol (NTP) IPv4 broadcast server on the specified interface, use the ntp
broadcast command. To disable the NTP IPv4 broadcast server, use the no form of this command.
Syntax Description
destination ip-address
key key-id
version number
Defaults
None
Command Modes
Interface configuration mode
Command History
Release
6.0(2)U(2)1
Usage Guidelines
Use NTP broadcast or multicast associations when time accuracy and reliability requirements are
modest, your network is localized, and the network has more than 20 clients. We recommend that you
use NTP broadcast or multicast associations in networks that have limited bandwidth, system memory,
or CPU resources.
Time accuracy is marginally reduced in NTP broadcast associations because information flows only one
Note
way.
This command does not require a license.
Examples
This example shows how to enable an NTP IPv4 broadcast server on the interface:
switch# configure terminal
switch(config)# interface ethernet 6/1
switch(config-if)# ntp broadcast destination 192.0.2.10
OL-29557-04
ntp broadcast [destination ip-address] [key key-id] [version number]
no ntp broadcast [destination ip-address] [key key-id] [version number]
(Optional) Configures the broadcast destination IPv4 address.
(Optional) Configures the broadcast authentication key number. The range
is from 1 to 65535.
(Optional) Configures the NTP version. The range is from 2 to 4.
Modification
This command was introduced.
Cisco Nexus 3000 Series NX-OS System Management Command Reference
ntp broadcast
-SM-135

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents