Table of Contents
Advertisement
10-6. TROUBLESHOOTING FLOW
A Check of indoor fan motor
The indoor fan motor error has occurred, and the indoor fan does not operate.
Turn OFF the power supply.
Is there any foreign matter that interferes
the rotation of the line flow fan?
Yes
Remove the foreign matter and
adjust the line flow fan.
Is there 325 V DC
between CN211
and
(–) ?
No
Replace the indoor power
P.C. board.
The indoor fan motor error has occurred, and the indoor fan repeats "12-second ON and 30-second OFF" 3 times, and then stops.
Measure the voltage between CN211
(+) and
(–) while the fan motor is
rotating.
Replace the indoor power P.C.
board.
Pay enough attention to the high voltage on the fan motor connector CN211.
Turn ON the power supply, wait 5 seconds or more, and then press
EMERGENCY OPERATION switch.
Measure the supply voltage as follows within 12 seconds after EMER-
GENCY OPERATION switch is pressed.
If more than 12 seconds passes, turn OFF the power supply and turn it
ON again, then measure the voltage.
No
<Indoor power P.C. board>
1. Measure the voltage between CN211
2. Measure the voltage between CN211
<Indoor electronic control P.C. board>
3. Measure the voltage between CN102
If more than 12 seconds passes after EMERGENCY OPERATION switch
is pressed, the voltage measured at 2. above goes 0 V DC although the
indoor P.C. board is normal.
Does the voltage between CN211
(+) and
(–) on the power P.C. board
(+)
rise to the range of 3 to 6 V DC within
Yes
12 seconds after EMERGENCY
OPERATION switch is pressed?
Does the voltage between CN102
(+) and JPG (GND)(–)/CN102
(–)* on the indoor electronic control
P.C. board fall to 2 V or less within
Yes
12 seconds after EMERGENCY
OPERATION switch is pressed?
Is it unchanged holding 0
or 15 V DC?
Replace the indoor fan motor.
Is it unchanged holding 0
or 5 V DC?
Yes
(Unchanged)
(+) and
(+) and
(+) and JPG(GND)(–).
Replace the indoor fan motor.
Yes
No
Replace the indoor electronic
No
control P.C. board.
* JPG: MSZ-EF∙VG-
CN102
Measure the voltage CN102
and JPG (GND)(–)/CN102
on the indoor electronic control
No
P.C. board when the fan motor is
(Changed)
rotating.
Yes
(Unchanged)
Replace the indoor elec-
tronic control P.C. board.
No
(Changed)
34
(–).
(–).
,
E1
ET1
: MSZ-EF∙VG-
,
, MSZ-EF-VGK-
E2
ET2
(+)
(–)*
,
E1
ET1
Hide quick links:
Advertisement
Table of Contents
