Table of Contents
Advertisement
15.6 Note for Customers Who Cut Their Own Paper
Customers who cut their own paper may experience:
• An increase of paper dust in the machine
• Shortening the life of the machine's fixing rollers due to excessive wear from the
rough side of the cut paper
• Paper jams due to paper dust getting into areas of the machine where it is not
meant to be
• Improper paper feeding
• Paper registration inaccuracies
Follow the precautions below to minimize the above issues:
• Have a process in place to regularly make sure that the cutting blades are
sharpened, and that cuts are made as clean as possible.
• Place the paper with the factory mill cut sides facing to the right (leading edge),
and to the front of the machine.
• Pay special attention to the paper grain orientation when cutting it. For more
information on paper grain, see
• The best results for consistency and front to back registration are obtained by
using factory mill cut, digital compatible paper.
15.7 Media Feed Locations
As with all Canon copiers, certain feed locations within the device are capable of
feeding specific media sizes and weights.
When considering media, make sure the media is within the proper size and weight
parameters of the feed location. Once the desired media is selected the
appropriate feed location must be selected.
IMPORTANT
• If the room temperature where the machine and paper are located is below 65°F
(18°C), the imagePRESS must slow down to account for the low paper
temperature, and ensure image quality; especially when using heavy paper. The
machine's productivity can be improved per paper source by setting the Adjust
Fixing of Paper Sources mode in Device Management Settings in System
Settings (from the Additional Functions screen) to 'Standard', instead of 'Fixing
Priority'. However, any productivity gains achieved may affect the image quality.
Image quality is not affected, however, if the customer is printing text only.
• The Adjust Fixing of Paper Sources mode does not have to be set if the paper
temperature is between 68°F to 80.6°F (20°C to 27°C).
• The Adjust Fixing of Paper Sources mode is only available if it is enabled in the
Service Mode.
Version 3
"Paper Grain and Curl,"
imagePRESS 1110+ Customer Expectations Document
on p. 69.
Page 70
Advertisement
Table of Contents
