Canon GP335 Service Manual page 264

Hide thumbs Also See for GP335:

CHAPTER 8 PAPER DECK

3. Removing the Deck Main Motor

1) Disconnect the deck from the copier, and

remove the screw; then, detach the rear

2) Disconnect the two connectors [1], and

remove the four screws [2]; then, detach

the deck main motor [3]. (At this time,

take care not to damage the gear at the tip

of the motor spindle.)

Figure 8-325

4. Removing the Deck Lifter Motor

1) Open the compartment of the deck, and

remove any paper.

2) Turn on the copier's power switch. If the

lifter is up, push the sensor lever [1] of the

paper supply position sensor inside the

compartment. Stop the lifter [2] when it is

about 7 cm from the bottom plate of the

compartment, and insert a hex wrench [4]

into the hole in the lifter drive shaft [3] to

prevent the shaft from rotating.

Figure 8-326

Figure 8-327

Chapters

Gp405 Gp405sm