Canon GP335 Service Manual page 387

Hide thumbs Also See for GP335:

IV. INSTALLING THE

CONTROL CARD V

Before turning off the main power

switch, check to make sure that the

image/memory lamp is off.

1. Removing the Control Panel

1) Remove the following to detach the inside

Feeding assembly lever (after

releasing the feeding assembly)

Drum unit (after releasing the

developing assembly)

Registration roller tab

Top cassette

2) Lock the developing assembly, and

remove the five screws; then, detach the

inside cover.

3) Free the harness of the shortage connector

from the edge saddle, and disconnect the

shorting connector. (The shorting

connector will not be used.)

Shorting connector

Figure 12-401

CHAPTER 12 INSTALLATION

4) Remove the control panel, and turn it over

Grounding plat (1 pc.; 1 screw)

Connectors (4 pc.)

2. Preparing for the Control Card

1) Remove the inlet face plate.

Inlet face plate

Figure 12-402

2) Remove the screw of the face plate.

Screw of the face plate

Figure 12-403

Chapters

Gp405 Gp405sm