Canon imagePROGRAF GP-4000 Online Manual page 99

Hide thumbs Also See for imagePROGRAF GP-4000:

Table of Contents

• Be careful not to drop the roll and hurt yourself when loading it.

• Be careful not to pinch your fingers between the Roll Holder shaft and the guide grooves (B) when

loading the roll paper.

• If the leading edge of the roll paper is secured with tape or a paper band so that it will not unravel,

remove the tape or paper band before loading the roll paper into the roll holder slot.

If you load the paper into the roll holder slot with the leading edge secured, only part of the roll

paper is fed to the paper feed slot, resulting in damage to the roll paper.

• If the leading edge of the roll paper is cut crooked or folded, it may not be fed correctly. Cut the

leading edge of the roll paper with scissors or the like and straighten it.

• Load the roll paper so that it is not loaded in the opposite direction.

• Make sure there is no slack in the roll paper, and then load it.

• Depending on the surrounding environment, the leading edge of roll paper is stuck because of

static electricity or humidity so that the roll paper may not be able to be fed correctly. In this case,

set Roll paper auto feed to Disable, and then feed the roll paper.

• If the roll paper is decentered, it may not be able to be fed correctly. In this case, set Roll paper

auto feed to Disable, and then feed the roll paper.

• When Roll paper auto feed is Enable and if you attach the roll holder without the roll paper

loaded on the roll holder, Preparing to feed the paper... appears on the operation panel. In this

case, press the Stop button on the operation panel to cancel feeding.

• For the procedure for attaching the roll paper to the Roll Holder, see

4. Change Roll Holder Lock switch on roll unit to locked position.

"Loading Rolls on the Roll

Troubleshooting