Installing Or Replacing A 3-Kw Dc Power Supply - Cisco Nexus 9508 Hardware Installation Manual
Aci-mode switch
Hide thumbs
Also See for Nexus 9508:
- Hardware installation manual (118 pages) ,
- Hardware installation manual (152 pages)
Table of Contents
Advertisement
Replacing or Installing Modules, Fan Trays, and Power Supplies
Step 4
Connect the Saf-D-Grid connector on the other end of the power cable to the Saf-D-Grid receptacle on the power supply.
Step 5
Turn on the circuit breaker for the DC power source circuit.
Step 6
Turn on the power supply by pressing its power switch to on.
Step 7
Verify that the OUT LED turns on and becomes green.
Note
If you use both inputs, the IN LED is green. If you use only one input, the IN LED is blinking green.
Installing or Replacing a 3-kW DC Power Supply
Before you begin
• The power source must be installed within reach of the power cables.
Installing or Replacing a 3-kW DC Power Supply
Cisco Nexus 9508 ACI-Mode Switch Hardware Installation Guide
77
Advertisement
Table of Contents
