Table of Contents
Advertisement
■ HV-TR
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > HV-TR
2TR-TGT1
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
2TR-TGT2
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
1TR-TGK1
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Sec trns indiv set tgt crrnt adj: set 1
To adjust the target current of secondary transfer for setting 1.
The target current that is set here is applied to the Secondary Transfer Outer Roller.
As the value is incremented by 1, the current value changes.
+: Increase
-: Decrease
Increase the value when low-voltage mottled image or toner scattering on solid image occurs.
Decrease the value when high-voltage mottled image or density loss due to excessive transfer
occurs.
When an image failure (mottled image, density loss due to excessive transfer, toner scattering on
solid image, etc.) occurs on all paper types
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Increase/decrease the value by 1 while checking the symptom each time.
-5 to 5
0
Sec trns indiv set tgt crrnt adj: set 2
To adjust the target current of secondary transfer for setting 2.
The target current that is set here is applied to the Secondary Transfer Outer Roller.
As the value is incremented by 1, the current value changes.
+: Increase
-: Decrease
Increase the value when low-voltage mottled image or toner scattering on solid image occurs.
Decrease the value when high-voltage mottled image or density loss due to excessive transfer
occurs.
When an image failure (mottled image, density loss due to excessive transfer, toner scattering on
solid image, etc.) occurs on all paper types
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Increase/decrease the value by 1 while checking the symptom each time.
-5 to 5
0
Adj sgl Bk pry trns ATVC tgt crrnt
To adjust the offset of the target current value for single Bk-color upon primary transfer ATVC
control.
Increase the value when spots, mottled image, or image failure due to insufficient transfer current
occurs.
Decrease the value when image fogging due to transfer memory or drum memory due to strong
transfer current occurs.
When an image failure due to the primary transfer occurs
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-5 to 5
0
560
9. Service Mode
Advertisement
Table of Contents
Troubleshooting
