Chapter 2: Initial System Setup And Configuration; Setting Up Your System; Idrac Configuration; Options To Set Up Idrac Ip Address - Dell EMC PowerEdge T440 Installation And Service Manual
Hide thumbs
Also See for EMC PowerEdge T440:
- Installation and service manual (156 pages) ,
- Simple operation manual (9 pages) ,
- Manual (150 pages)
Table of Contents
Advertisement
Initial system setup and configuration
Topics:
•
Setting up your system
•
iDRAC configuration
•
Options to install the operating system
Setting up your system
Perform the following steps to set up your system:
Steps
1. Unpack the system.
2. Install the system into the rack. For more information about installing the system into the rack, see the Rail Installation Guide
at www.dell.com/poweredgemanuals.
3. Connect the peripherals to the system.
4. Connect the system to its electrical outlet.
5. Power on the system by pressing the power button or by using iDRAC.
6. Power on the attached peripherals.
For more information about setting up your system, see the Getting Started Guide that shipped with your system.
iDRAC configuration
The Integrated Dell Remote Access Controller (iDRAC) is designed to make system administrators more productive and improve
the overall availability of Dell systems. iDRAC alerts administrators about system issues and enables them to perform remote
system management. This reduces the need for physical access to the system.
Options to set up iDRAC IP address
To enable communication between your system and iDRAC, you must first configure the network settings based on your
network infrastructure.
NOTE:
For static IP configuration, you must request for it at the time of purchase.
This option is set to DHCP by Default. You can set up the IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings
Dell Integrated Dell Remote Access Controller User's Guide at
utility
Dell Deployment
Dell Deployment Toolkit User's Guide at
Toolkit
Toolkit
Dell Lifecycle
Dell Lifecycle Controller User's Guide at
Controller
NOTE:
To access iDRAC, ensure that you connect the ethernet cable to the iDRAC9 dedicated network port. You can also
access iDRAC through the shared LOM mode, if you have opted for a system that has the shared LOM mode enabled.
24
Initial system setup and configuration
www.dell.com/poweredgemanuals
www.dell.com/openmanagemanuals
www.dell.com/poweredgemanuals
2
> OpenManage Deployment
Advertisement
Table of Contents
