System Cover; Removing The System Cover - Dell EMC PowerEdge T440 Installation And Service Manual
Hide thumbs
Also See for EMC PowerEdge T440:
- Installation and service manual (156 pages) ,
- Simple operation manual (9 pages) ,
- Manual (150 pages)
Table of Contents
Advertisement
2. Place the system on its side on a flat, stable surface.
3. If installed,
remove the system
Steps
1. Align the two retention hooks on the rear wheel unit with the two slots on the base of the system, and insert the hooks into
the slots.
2. Push the rear wheel unit toward the back of the system and using a Phillips #2 screwdriver secure the unit in place using a
single screw.
3. Align the two retention hooks on the front wheel unit with the two slots on the base of the system, and insert the hooks into
the slots.
4. Push the front wheel unit toward the front of the system and using a Phillips #2 screwdriver secure the unit in place using a
single screw.
Figure 22. Installing caster wheels
Next steps
Follow the procedure listed in
System cover
Removing the system cover
Prerequisites
1. Follow the safety guidelines listed in
2. Turn off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet and peripherals.
4. If installed,
remove the front
5. Place the system on a flat, stable surface.
feet.
After working inside your
Safety
instructions.
bezel.
system.
Installing and removing system components
35
Advertisement
Table of Contents
