Table 18. Expansion card configuration: 1 processor
Card Type
NIC(Broadcom)
Card, Network ((Broadcom/Intel/Emulex,
Qlogic)
BOSS M.2 (SATA) (Dell)
Table 19. Expansion card configuration - 2 processors
Card Type
GPGPU (NVIDIA, AMD)
Card, Network (Broadcom, Intel)
NIC(Intel)
PERC9/ 9.14G (FXN)
RAID - PERC9+ (Internal) (Dell)
RAID - PERC10 (Internal) (Dell)
RAID - PERC10 (External)(Dell)
NIC(Broadcom)
Card, Network ((Broadcom/Intel)
Card,Controller (Emulex, Qlogic)
BOSS M.2 (SATA) (Dell)
GPU card installation guidelines
Observe the following guidelines while installing a GPU card:
● GPU is supported in the rack and tower mode configuration.
● GPU can be installed only on systems that have 1100 W (recommended) or higher power supply units.
● Each GPU card supports up to 32 GB of dedicated GDDR5 memory.
● Supports one GPU on x16 slot (slot 3) with two processors on it
● Specific GPU cards need the use of the dongle power cable.
GPU card installation restrictions
● Supports only single slot GPU card
● Supports only active (embedded fan) GPU card
● High power (>75 W) GPU cards that use GPU AUX cable should have dual system fans without redundancy.
Removing a expansion card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air
shroud.
4.
Remove the expansion card
Steps
1. If installed, disconnect the data cables from the PERC card and/or the power cables from the GPU card.
Slot Priority
4,5,2
4,5,2
4,5,2
Slot Priority
3
1,2,4,5,3
1,2,4,5,3
4,5,3,2
4,5,3,2
4,5,3,2
4,5,3,2
4,5,3,2
4,5,3,2
4,5,3,2
4,5,3,2
Safety
instructions.
Before working inside your
holder.
system.
Installing and removing system components
Maximum Allowed
3
3
3
Maximum Allowed
1
5
5
4
4
4
4
4
4
4
4
75