Makita TW009G Instruction Manual page 9
Hide thumbs
Also See for TW009G:
- Instruction manual (97 pages) ,
- Instruction manual (85 pages) ,
- Instruction manual (89 pages)
Advertisement
Available languages
Available languages
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
When the reversing switch lever is on the side A or side B
and the switch trigger is pulled, the front lamp turns on. To
turn off, release the switch trigger. The front lamp goes out
approximately 10 seconds after releasing the switch trigger.
► Fig.5: 1. Front lamp
Changing brightness
To change the brightness, press the button
ness has three levels. Every time you press the button
the brightness decreases and finally goes out. When the
lamp status is off, the front lamp will not turn on even if the
switch trigger is pulled. To turn on the lamp status again,
press the button
. The brightness will return to the highest.
► Fig.6: 1. Switch panel 2. Button
NOTE: To confirm the lamp status, pull the switch
trigger. When the front lamp lights up by pulling the
switch trigger, the lamp status is ON. When the front
lamp does not light up, the lamp status is OFF.
NOTE: When the tool is overheated, the front lamp flashes
for one minute, and then the lamps on the switch panel go
off. In this case, cool down the tool before operating again.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the front lamp. Be careful not to scratch the lens of
the front lamp, or it may lower the illumination.
NOTE: While pulling the switch trigger, the lamp
status cannot be changed.
NOTE: For approximately 10 seconds after releasing
the switch trigger, the lamp status can be changed.
Changing the application mode
Changing the impact force
You can change the impact force in four steps: 4 (max), 3 (hard), 2 (medium), and 1 (soft).
This allows a tightening suitable to the work.
The level of the impact force changes every time you press the button
You can change the impact force within approximately one minute after releasing the switch trigger.
NOTE: You can extend the time to change the impact force approximately one minute if you press the but-
ton
or
.
► Fig.7: 1. Button
Application mode
(Impact force grade
displayed on panel)
4 (Max)
3 (Hard)
. The bright-
Maximum blows
TW009G
TW010G
-1
1,750 min
(/min)
-1
1,500 min
(/min)
Light mode
You can use the tool as a light.
To turn on the light, set the reversing switch lever in the
neutral position and pull the switch trigger.
The front lamp keeps lighting up for approximately one
hour.
To turn off the light, pull the switch trigger again.
Changing brightness
To change the brightness, press the button
brightness has three levels. Every time you press the
button
, the brightness decreases. The brightness
will return to the highest when operating in the lowest
,
brightness.
NOTE: You cannot change the application mode
while the light mode is on. The lamps on the switch
panel do not light up when the light mode is on.
NOTE: You cannot turn on/off the lamp status when
the light mode is on.
NOTE: The light mode does not work when the tool/
battery protection system activates or the battery
capacity is not enough.
.
Purpose
Tightening with the maximum force and
speed.
Tightening when the force and the speed
are desired.
Tightening with less force and speed
than Max mode (easier to control than
Max mode).
Tightening when the force and the speed
are desired.
9 ENGLISH
. The
Advertisement
