Table of Contents
Advertisement
4
Parts Replacement and Clearning > Image Formation System > Removing the Pre-transfer Charging Assembly Shutter Unit
Removing the Pre-transfer Charging Assembly Shutter
Unit
<Preparation>
1. Open the Front Cover.
2. Open the Inner Cover. (Refer to "Removing the Primary Charging Assembly")
3. Remove the Pre-transfer Charging Assembly. (Refer to page 4-108)
<Procedure>
1) Move the Shield Plate Retainer Block to open the Shield Plate in the direction of the arrow.
• 1 Screw (to loosen)
2) Remove the claw at the edge of the Shutter.
4
Parts Replacement and Clearning > Image Formation System > Removing the Pre-transfer Charging Assembly Shutter Unit
CAUTION:
Be careful not to remove the screw and the Screw Gear when removing the Pre-transfer
Charging Assembly Shutter Unit.
3) Hold the screw to remove the Pre-transfer Charging Assembly Shutter Unit while the Motor
Unit is installed.
• 3 Screws
Loosen
4) Remove the Motor Unit from the Pre-transfer Charging Assembly Shutter Unit.
• 3 Claws
F-4-218
F-4-219
x3
x3
4-150
F-4-220
F-4-221
4-150
Advertisement
Table of Contents
Troubleshooting
