Table of Contents
Advertisement
5
Adjustment > When replacing parts > Image Formation System > Photosensitive Drum
■
Pre-transfer Charging Assembly
<Procedure of parts replacement>
see "Removing the Pre-transfer Charging Assembly," on p. 4-106.
<Procedure of adjustment>
1) Clear the parts counter. (COPIER>COUNTER>DRBL-1>PO-UNIT)
2) Clean the Charging Wire. (COPIER>FUNCTION>CLEANING>WIRE-CLN)
■
Pre-transfer Charging Wire
<Procedure of parts replacement>
see "Replacing the Pre-transfer Charging Wire," on p. 4-110.
<Procedure of adjustment>
1) Clear the parts counter. (COPIER>COUNTER>PRDC-1>PO-WIRE)
2) Clean the Charging Wire. (COPIER>FUNCTION>CLEANING>WIRE-CLN)
5
Adjustment > When replacing parts > Image Formation System > Photosensitive Drum
■
Photosensitive Drum
<Procedure of parts replacement>
see "Removing the Photosensitive Drum," on p. 4-122.
<Procedure of adjustment>
1) Clear the parts counter. (COPIER>COUNTER>DRBL-1>PT-DRM)
2) Replace the ROM connected to the host machine with the drum ROM included in the drum.
MEMO:
If the ROM is not replaced, the replaced drum and the drum-unique data stored
in the ROM data are not matched. As a result, when the 2D shading function is
enabled, it is not functioned normally.
2-1)
Remove the Drum EEROM.
•
1 Screw
•
1 Connector
5-9
F-5-7
F-5-7
5-9
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
