Paper Size Not Detected - Canon imagePROGRAF iPF9000S User Manual
Hide thumbs
Also See for imagePROGRAF iPF9000S:
- Troubleshooting manual (191 pages) ,
- Brochure (8 pages) ,
- User manual (807 pages)
Table of Contents
Advertisement
Paper size not detected.
Paper has been loaded askew, or warped paper has
been loaded.
Insufcient paper for job
The printer has received a print job longer than the
amount of roll paper left.
* When using the Media Take-up Unit, either hold down the Stop button for a second or more to cancel
printing or press the Online button to continue printing. However, if you continue printing, the roll paper
may run out during the print job and you may not be able to print all of the document.
Cause
Cause
Corrective Action
Reload paper straight, in the correct position.
(→P.120)
(→P.147)
Remove the Roll Holder, insert the roll on the Roll
Holder rmly until it reaches the ange, and load the
Roll Holder in the printer again.
(→P.116)
Corrective Action
Follow the steps below to replace the roll.
1.
Press the Load/Eject button and remove the roll.
(→P.127)
(→P.128)
(→P.129)
2.
Load a roll with enough paper left.
(→P.116)
(→P.119)
(→P.120)
3.
If no barcode was printed on the roll, specify the
paper type.
(→P.124)
4.
Specify the paper length, unless a barcode has
been printed on the roll and you have deactivated
the automatic detection function of the remaining
roll paper.
(→P.125)
Hold down the Stop button for a second or more to
cancel printing.
Press the Online button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of the
document.
Messages regarding paper
Error Message 785
Advertisement
Table of Contents
