Initializing The Network Settings - Canon imagePROGRAF iPF9000S User Manual
Hide thumbs
Also See for imagePROGRAF iPF9000S:
- Troubleshooting manual (191 pages) ,
- Brochure (8 pages) ,
- User manual (807 pages)
Table of Contents
Advertisement
Initializing the Network Settings
Use RemoteUI to restore the network settings to the default values as follows.
Important
•
Initializing the network settings will also restore the default value of the printer's IP address. As a result,
the RemoteUI page cannot be displayed in the web browser after this procedure.
•
For instructions on reconguring the IP address, see "Conguring the IP Address on the Printer".
(→P.580)
•
For details on RemoteUI, see "Using RemoteUI". (→P.584)
1.
Start the web browser and enter the following URL in the Location (or Address) box to display
the RemoteUI page.
http://"printer IP address or name"/
Example: http://xxx.xxx.xxx.xxx/
2.
Select Administrator Mode and click Logon.
3.
If a password has been set on the printer, enter the password.
4.
Click Network in the Device Manager menu at left to display the Network page.
5.
Click Reset to Default settings in the lower-right corner of the Network Interface group.
6.
After conrming the message, click OK to restore the network settings to the default values.
Note
•
You can also use imagePROGRAF Device Setup Utility or the Control Panel to restore the default
network settings.
•
If you use the Control Panel to initialize the network settings, press the Menu button to display MAIN
MENU, and then press ▲, ▼, and ► to select Interface Setup → Ethernet Driver → Init. Settings →
Yes (in this order), and nally press the OK button.
Network Setting
Network Setting 593
Advertisement
Table of Contents
