No-Beep Symptoms; Lcd-Related Symptoms - Lenovo ThinkPad Edge 11 Hardware Maintenance Manual
Hardware maintenance manual
Hide thumbs
Also See for ThinkPad Edge 11:
- Hardware maintenance manual (130 pages) ,
- Manual de déploiement (62 pages) ,
- Implementierungshandbuch (62 pages)
Table of Contents
Advertisement
Table 3. Error messages (continued)
Symptom or error (beeps, if any)
DRAM is not well plugged.
(one short beep, pause, three short beeps, pause, three
short beeps, pause, one short beep.)
Operating system not found.
System Configuration Data Read Error
(two short beeps)
No-beep symptoms
Table 4. No-beep symptoms
Symptom or error
No beep, power-on indicator on, LCD blank, and no
POST.
No beep, power-on indicator on, and LCD blank during
POST.
The power-on password prompt appears.
The hard-disk password prompt appears.
LCD-related symptoms
Important: The TFT LCD for the notebook computer contains many thin-film transistors (TFTs). The
presence of a small number of dots that are missing, discolored, or always lighted is characteristic of TFT
LCD technology, but excessive pixel problems can cause viewing concerns.
If the LCD you are servicing has two or less visible defective pixels, it should not be considered faulty.
However, if the LCD has three or more visible defective pixels, it will be deemed as defective by Lenovo and
it should be replaced.
Notes:
• This policy applies to all ThinkPad Notebooks purchased on 1 January, 2008 or later.
• Lenovo will not provide replacement if the LCD is within specification as we cannot guarantee that
any replacement LCD will have zero pixel defects.
• One pixel consists of R, G, B sub-pixels.
42
Hardware Maintenance Manual
FRU or action, in sequence
Reinstall the memory card.
1. Check that the operating system has no failure
and is installed correctly.
2. Enter BIOS Setup Utility and see whether the hard
disk drive is properly identified. If you still see the
same error message, check the boot sequence.
3. Reinstall the hard disk drive.
4. Reinstall the operating system.
Press F1 to enter BIOS Setup Utility. Press F9, and
Enter to load the default setting. Then save the current
setting by pressing F10, and restart the computer.
FRU or action, in sequence
1. Make sure that every connector is connected
tightly and correctly.
2. DIMM.
3. System board.
1. Reseat DIMM.
2. System board.
A power-on password or a supervisor password is set.
Type the password and press Enter.
A hard-disk password is set. Type the password and
press Enter.
Hide quick links:
Advertisement
Table of Contents
