Table of Contents
Advertisement
5) Turn ON DIPSW 1[a] in Finisher Control PCB Assembly, and then turn ON the main power switch.
6) When the machine has started up, turn ON all of DIPSW 1, 2, 3 and 4 in SW3, and then push SW2 once.
This will allow the swing guide of the finisher to automatically perform open/close operation and memorizing
the swing standard position.
[Reference] Operation time is about 2 seconds.
7) When the operation in the step 6) has been completed, turn OFF the main power switch, and then turn
OFF all of DIPSW 1, 2, 3 and 4 in SW3 on Finisher Control PCB Assembly.
8) Turn ON the main power switch.
9) Perform a test copy to check if the symptom of paper overhanging the edge or uneven stacking in the
finisher tray has improved.
pg. 153
Hide quick links:
Advertisement
Table of Contents
