Administration
PoE
PoE
NOTE
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
TEMP
Voltage
Current
Output Power
Input Power
TX Fault
LOS
Related Commands
Command
show cablestatus
The following commands configure the Power-over-Ethernet functionality on the
switch.
These commands are valid only for the SF 200E-24P and SF 200E-48P switches.
lldp med transmit-tlv
Use this command to specify the optional Type Length Values (TLVs) in the LLDP
MED set transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs) on
a specific port. Use the no form of the command to exclude the specified TLV for
the specified port.
lldp med transmit-tlv [capabilities] [ex-pse] [inventory] [location] [network-policy]
no lldp med transmit-tlv [capabilities] [ex-pse] [inventory] [location] [network-
policy]
Internally measured transceiver temperature.
Internally measured supply voltage.
Measured TX bias current.
Measured TX output power in milliwatts.
Measured RX received power in milliwatts.
Transmitter fault.
Loss of signal.
Description
Displays the cable connection status on a selected port.
2
38