Table of Contents
Advertisement
Initializing TPM for users
Steps
1. Initialize the TPM.
For more information, see
2. The TPM Status changes to Enabled, Activated.
Initializing the TPM 1.2 for users
Steps
1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3. From the TPM Security option, select On with Preboot Measurements.
4. From the TPM Command option, select Activate.
5. Save the settings.
6. Restart your system.
Initializing the TPM 2.0 for users
Steps
1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3. From the TPM Security option, select On.
4. Save the settings.
5. Restart your system.
Control panel
This is a service technician replaceable part only.
Removing the control panel assembly
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the front
bezel.
4. Disconnect the control panel cable and the control panel USB cable from the connector system board.
NOTE:
Remove the control panel cables form the cable tie.
Steps
1. Using a Phillips 2 screwdriver, remove the screws that secure the system side cover to the chassis.
2. Tilt and slide the system side cover towards the rear of the system and remove the system side cover.
Initializing the TPM for
users.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
105
Advertisement
Table of Contents
