Chapter 4: Installing And Removing System Components; Safety Instructions; Before Working Inside Your System; After Working Inside Your System - Dell Precision Rack 7910 Owner's Manual
Hide thumbs
Also See for Precision Rack 7910:
- Owner's manual (142 pages) ,
- Quick start manual (2 pages) ,
- Setup manual (3 pages)
Table of Contents
Advertisement
Installing and removing system components
Safety instructions
NOTE:
Whenever you need to lift the system, get others to assist you. To avoid injury, do not attempt to lift the system by
yourself.
WARNING:
Opening or removing the system cover when the system is on may expose you to a risk of electric
shock.
CAUTION:
Do not operate the system without the cover for a duration exceeding five minutes.
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
NOTE:
Dell recommends that you always use a static mat and static strap while working on components inside the system.
Before working inside your system
Steps
1. Turn off the system, including any attached peripherals.
2. Disconnect the system from the electrical outlet and disconnect the peripherals.
3. Remove the system cover.
After working inside your system
Steps
1. Install the system cover.
2. Reconnect the system to its electrical outlet.
3. Turn the system on, including any attached peripherals.
Recommended tools
You need the following tools to perform the removal and installation procedures:
● Key to the bezel lock. This is only required when you have a bezel.
● #2 Phillips screwdriver
12
Installing and removing system components
4
Advertisement
Table of Contents
Troubleshooting
