Installing The Riser 1 Blank; Removing Expansion-Card Risers - Dell Precision Rack 7910 Owner's Manual
Hide thumbs
Also See for Precision Rack 7910:
- Owner's manual (142 pages) ,
- Quick start manual (2 pages) ,
- Setup manual (3 pages)
Table of Contents
Advertisement
Figure 20. Removing and installing the riser 1 blank
a. slot on the chassis
b. tab (2)
c. riser 1 blank
Installing the riser 1 blank
Prerequisites
1. Align the blank with the slot on the chassis.
2. Insert it into the chassis until it clicks into place.
Removing expansion-card risers
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
3. If installed, remove any expansion card installed on riser 2 and 3.
NOTE:
The expansion-card riser 1 can be used only when both the processors are installed.
Steps
Holding the slots on the expansion-card riser, lift the riser from the riser connector on the system board.
NOTE:
To remove expansion-card risers 2 and 3, hold the edges of the expansion-card riser.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
47
Advertisement
Table of Contents
Troubleshooting
