Installing The Control Panel - Dell Precision Rack 7910 Owner's Manual
Hide thumbs
Also See for Precision Rack 7910:
- Owner's manual (142 pages) ,
- Quick start manual (2 pages) ,
- Setup manual (3 pages)
Table of Contents
Advertisement
Figure 42. Removing and installing the information tag
a. information tag
b. tab
c. slot
3. Remove the retaining screw that secures the control panel to the chassis.
4. Push the control panel out of the chassis.
5. Slide the control panel into the chassis and tighten the screw.
Installing the control panel
Prerequisites
1. Ensure that you read the
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
Steps
1. Replace the blank information tag in the new control panel with the information tag retained from the old control panel.
NOTE:
Information tag lists system information such as Service Tag, NIC, MAC address, and so on.
2. To install the information tag, push the information tag into the control-panel slot.
3. Connect all the applicable cables to the control panel.
4. Slide the control panel into the slot in the chassis.
Next steps
Follow the procedure listed in
Safety
instructions.
After working inside your system
.
Installing and removing system components
77
Advertisement
Table of Contents
Troubleshooting
