Related video
http://www.Dell.com/QRL/Server/PER730/PSU
Results
To see a video on how to remove & install the power supplies, scan this QR code, or click here:
Workstation/R7910/PSU
Installing an AC power supply unit
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
Steps
1. Verify that both the power supply units are the same type and have the same maximum output power.
NOTE:
The maximum output power (shown in watts) is listed on the PSU label.
2. If applicable, remove the power supply unit blank.
3. Slide the new power supply unit into the chassis until the power supply unit is fully seated and the release latch snaps into
place.
NOTE:
If you unlatched the cable management arm, re-latch it. For information about the cable management arm, see
the system's rack documentation.
4. Connect the power cable to the power supply unit and plug the cable into a power outlet.
CAUTION:
When connecting the power cable, secure the cable with the strap.
NOTE:
When installing, hot-swapping, or hot-adding a new power supply unit, wait for 15 seconds for the system to
recognize the power supply unit and determine its status. The power supply redundancy may not occur until discovery
is complete. Wait until the new power supply unit is discovered and enabled before you remove the other power supply
unit. The power-supply unit status indicator turns green to signify that the power supply unit is functioning properly.
http://www.Dell.com/QRL/
Installing and removing system components
69