Canon imageRUNNER ADVANCE DX C5870i Service Manual page 630
Hide thumbs
Also See for imageRUNNER ADVANCE DX C5870i:
- Faq manual (100 pages) ,
- Manual (96 pages) ,
- Faq manual (48 pages)
Table of Contents
Advertisement
E730-C001-00
Detection Description
Remedy
E731-3000-00
Detection Description
Remedy
E731-3001-00
Detection Description
Remedy
E731-3002-00
Detection Description
Remedy
E731-3015-00
Detection Description
Remedy
E732-0001-00
Detection Description
Remedy
E732-0001-04
Detection Description
Remedy
Error in SSD access
An error occurred when accessing the SSD.
[Related parts]
- Harness between the Main Controller PCB and the SSD Unit
- SSD Unit
- Main Controller PCB (UN41)
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Format the SSD and reinstall the system software using SST or a USB flash drive.
2. Check/replace the related harness/cable, connector and parts.
Main Controller PCB error
Unable to recognize the SURF Board.
[Related parts]
- Main Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
Main Controller PCB error
Failure of SURF initialization.
[Related parts]
- Main Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
Main Controller PCB error
Failure of SURF initialization.
[Related parts]
- Main Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
Main Controller PCB error
Video data is not transmitted to CL1-G even though there is no problem in the software.
[Related parts]
- Main Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
Communication error
A communication error between the Scanner Unit and the Main Controller PCB was detected.
[Related parts]
- Harness between the Scanner Unit and the Main Controller PCB
- Scanner Unit
- Main Controller PCB (UN41)
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] Before replacing the Main Controller PCB, back up the service mode data and restore
the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMRES
Communication error
A communication error between the Scanner Unit and the Main Controller PCB was detected.
[Related parts]
- Harness between the Scanner Unit and the Main Controller PCB
- Scanner Unit
- Main Controller PCB(UN41)
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] Before replacing the Main Controller PCB, back up the service mode data and restore
the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMRES
618
8. Error/Jam/Alarm
- Quick Links:
- Table of Contents
- Paper Feed/Output Options
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
