Canon imageRUNNER ADVANCE DX C5870i Service Manual page 928
Hide thumbs
Also See for imageRUNNER ADVANCE DX C5870i:
- Faq manual (100 pages) ,
- Manual (96 pages) ,
- Faq manual (48 pages)
Table of Contents
Advertisement
COPIER (Service mode for printer) > OPTION (Specification setting mode) > FNC-SW
AMSOFFSW
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Additional Functions
Mode
Supplement/Memo
UA-OFFSW
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
MIB-NVTA
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
MIB-EXT
1
Enabling of AMS mode
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To enable the AMS mode.
When 0 is set, the AMS mode is enabled. The AMS mode is automatically enabled when the
following 2 conditions are satisfied.
- AMS license for an iR option is installed.
- AMS-supported Login application (User Authentication, etc.) is activated.
When enabling AMS mode
1) Check that AMS-supported Login application is activated.
2) Enter 0, and then press OK key.
3) Turn OFF/ON the main power switch.
4) Check that [Role Management] is displayed on remote UI.
0 to 1
0: AMS mode enabled, 1: AMS mode disabled
1
COPIER> OPTION> LCNS-TR> ST-AMS
(Remote UI) User Management> Authentication Management> Role Management
AMS: Access Management System
In AMS mode, [Role Management] is displayed on remote UI.
ON/OFF of unified auth function
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set ON/OFF of the Unified Authentication function.
Set 0 when not preferring to use the Unified Authentication function because of security concern.
Upon user's request (not to use the Unified Authentication function)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: ON, 1: OFF
0
Unified Authentication: A function with which it is considered that login authentication under it is
performed by logging in it using SSO-H.
RFC-compatible character stringMIB write
As default, MIB object which NVT-ASCII can be written exists in order to link with local UI entry
value. This violates RFC order, so a problem like garbled 2-byte characters may occur in the SNMP
monitoring system, such as other vendor's MPS.
Whether to allow writing of non-RFC-compatible character strings in MIB can be set using this
item.
When 1 is set, only the character strings which are strictly compatible with RFC are written. (Writing
operation is executed from the SNMP manager.) It is not linked with local UI.
Upon user's request (operation with RFC-compatible system)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 3
0: Compatible in a conventional manner, 1: RFC-compatible, 2 to 3: Not used
0
RFC: Document of internet-related technical standards
NVT-ASCII: Network Virtual Terminal-ASCII
For R&D
916
9. Service Mode
- Quick Links:
- Table of Contents
- Paper Feed/Output Options
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
