Canon imageRUNNER ADVANCE DX C5870i Service Manual page 496
Hide thumbs
Also See for imageRUNNER ADVANCE DX C5870i:
- Faq manual (100 pages) ,
- Manual (96 pages) ,
- Faq manual (48 pages)
Table of Contents
Advertisement
E014-0002-05
Detection Description
Remedy
E015-0003-05
Detection Description
Remedy
Fixing motor lock error
Detecting the unlocking of the fixing motor
[Related parts]
- Harness between the Feed Driver PCB (UN1/J309) and the Fixing Motor (M20/J2273)
- Harness between the Main Controller PCB (UN41/J74) and the Feed Driver PCB (UN1/J307)
- Harness between the DC Power Supply PCB (UN3/J811) and the Feed Driver PCB (UN1/J300)
- DC Power Supply PCB (UN3) (Unit of replacement: POWER SUPPLY ASSEMBLY)
- Main Controller PCB (UN41)
- Feed Driver PCB (UN54)
- Fixing Motor (M20)
- Fixing Unit
- Fixing Drive Unit
[Remedy]
1. Turn OFF and then ON the main power.
2. Check if the Fixing Unit is properly installed.
3. Check / replace the related harnesses / cables / connectors / parts.
Pre-registration disengagement timeout
When the disengagement/engagement operation of Pre-registration Roller failed to complete
within the specified time
[Related parts]
- Pre-checkout follower guide unit
- PAPER PICK-UP DRIVE ASSEMBLY
- Bundled wire between the Feed Driver PCB (UN1/J312) and the vertical path 1 motor (M13/
J2313)
- Bundle line between the Feed Driver PCB (UN1/J312) and the Pre-Registration Disengagement
HP Sensor (PS48/J2294)
- Bundle wire between a DC Power Supply PCB (UN3/J811) and Feed Driver PCB (UN1/J300)
- Feed Driver PCB (UN1)
- Vertical Path 1 Motor (M13)
- Pre-Registration Disengagement HP Sensor (PS48)
[Remedy]
- Visually check that there is no damage or abnormal wear of the separation drive connection part
of the pre-registration driven guide unit, and replace it if there is a problem.
- Visually check that there is no damage or abnormal wear on the separation drive connection part
of the Paper pickup drive assembly, and replace it if there is a problem.
- When checking bundled wires/cables and connectors, perform the following.
1.Reseat the connector and check for bent/broken pins/missing wires.
2.Visually check that there is no biting/disconnection in the bundle.
3.If there is a problem, replace the appropriate bundle/cable and components.
484
8. Error/Jam/Alarm
- Quick Links:
- Table of Contents
- Paper Feed/Output Options
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
