Canon imageRUNNER ADVANCE DX C5870i Service Manual page 620
Hide thumbs
Also See for imageRUNNER ADVANCE DX C5870i:
- Faq manual (100 pages) ,
- Manual (96 pages) ,
- Faq manual (48 pages)
Table of Contents
Advertisement
E614-4000-00
Detection Description
Remedy
E614-4001-00
Detection Description
Remedy
E614-4002-00
Detection Description
Remedy
Error in system on the FLASH PCB
The OS could not be recognized.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
[Related parts]
- FLASH PCB
- SSD Unit
- Main Controller PCB
[Remedy]Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the FLASH PCB again to check that
it is installed properly.
2. After replacing the FLASH PCB, reinstall the system software using SST or a USB flash drive.
3. Check that the SSD Unit and the cables are properly installed.
4. Enter safe mode, and format the SSD using SST or a USB flash drive.
5. If another error occurs, clear the error by performing the remedy for it.
6. Replace the Main Controller PCB.
Error in system on the FLASH PCB
The OS boot file was not found.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
[Related parts]
- FLASH PCB
- SSD Unit
- Main Controller PCB
[Remedy]Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the FLASH PCB again to check that
it is installed properly.
2. After replacing the FLASH PCB, reinstall the system software using SST or a USB flash drive.
3. Check that the SSD Unit and the cables are properly installed.
4. Enter safe mode, and format the SSD using SST or a USB flash drive.
5. If another error occurs, clear the error by performing the remedy for it.
6. Replace the Main Controller PCB.
Error in system on the FLASH PCB
The OS kernel was not found.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
[Related parts]
- FLASH PCB
- SSD Unit
- Main Controller PCB
[Remedy]Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the FLASH PCB again to check that
it is installed properly.
2. After replacing the FLASH PCB, reinstall the system software using SST or a USB flash drive.
3. Check that the SSD Unit and the cables are properly installed.
4. Enter safe mode, and format the SSD using SST or a USB flash drive.
5. If another error occurs, clear the error by performing the remedy for it.
6. Replace the Main Controller PCB.
608
8. Error/Jam/Alarm
- Quick Links:
- Table of Contents
- Paper Feed/Output Options
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
